6.0/6.4 Powerstroke Billet Hand Throttle
Free shipping (lower 48)
2 - In Stock
Works plug-n-play for 2005+ 6.0 and all 6.4 Powerstrokes
Will work with 2003-2004.5 trucks, but not plug-n-play; wiring instructions provided
- Increases throttle control through longer accelerator stroke, great for sled pulling
- Lever rides on sealed ball bearings for extremely smooth operation
- Handle throw is approximately 6.1 inches
- Adjustable throttle lever hard stops, comes preset
- Optional integrated and adjustable WOT switch available
- Handle grip pushbutton comes standard
- A latching pushbutton integrated into the handle grip (great for manual torque converter lockup, mechanical IPR valve, nitrous, and etc.). Latching = push and release latches button ON, push and release again turns OFF.
- The pushbutton comes pre-wired to a small spring clamp terminal block inside the housing, just run your accessory/load to the terminal block and your ready to go.
- Pushbutton is a high quality sealed, dustproof (MIL-PRF-8805 Design 3), billet aluminum bodied button that offers a mechanical life beyond 50,000 cycles (MIL-PRF-8805). The quality of this button meets military standard (MIL-PRF-8805).
- Utilizes new OEM (FORD) pedal sensor components for reliability
- Utilizes '05+ OEM pigtail connector (must extend harness, harness OPTIONAL)
- 100% designed, machined, assembled, and tested in-house
- Please note, the hand throttle must be mounted next too or near the drivers seat - due to the amount of handle throw, it cannot be mounted in front of, for example, a bench seat because the handle will hit the radio/dash at wide open throttle. Please consider this prior to placing an order.
We Also Recommend
