6.7 Powerstroke Billet Hand Throttle
Free shipping (lower 48)
1 - In Stock
For 2011-2016 Powerstrokes
- Increases throttle control through longer accelerator stroke, great for sled pulling
- Lever rides on sealed ball bearings for extremely smooth operation
- Handle throw is approximately 6.1 inches
- Adjustable throttle lever hard stops, comes preset
- Optional integrated and adjustable WOT switch available
- Handle grip pushbutton comes standard
- A latching pushbutton integrated into the handle grip (great for manual torque converter lockup, nitrous, and etc.).
- Latching: push and release latches button ON, push-and release again turns OFF.
- The pushbutton comes pre-wired to a spring clamp terminal block inside the housing, all you need to do is wire your accessory/device to the terminal block and your ready to go.
- Pushbutton is a high quality sealed, dustproof (MIL-PRF-8805 Design 3), billet aluminum bodied button that offers a mechanical life beyond 50,000 cycles (MIL-PRF-8805). The quality of this button meets military standard (MIL-PRF-8805).
- Optional wire harness for quick plug-and-play installation. This wire harness plugs into the trucks OEM harness, extending it to the hand throttle which eliminates the need of cutting/extending the trucks chassis side wire harness. Built in-house with OEM spec. terminal pins, wire seals, and connectors and has no splices. The length is 64 inches.
- Utilizes new OEM (FORD) pedal sensor components for reliability
- Uses OEM electrical connector (must extend OEM harness or purchase optional in-house built extension harness)
- 100% designed, machined, assembled, and tested in-house
- Please note, the hand throttle must be mounted next too or near the drivers seat - due to handle throw distance, it cannot be mounted in front of, for example, a bench seat because the handle will hit the radio/dash at wide open throttle. Please consider this prior to placing an order.